About Anand Patel
-
Education Level Diploma
-
Age 33 - 37 Years
-
Gender Male
-
Specialities EngineeringConstructionQA/QCInspection
-
Experience 10 - 15 Years
-
Viewed 25
About me
TOTAL YEARSÂ Â :14 YEARS + (INCLUDE ABROAD)
I having more than of 14 years’ Experience in QA/QC Inspector Welding, Piping, Mechanical, NDT, Inspection Engineer for Pipe mill inspection, Pipeline, Fabrication, Construction, Materiel Testing, Coordination, Painting/Coating, TPI, Vendor Inspection, Surveyor, Lead Auditor for the Upstream, Downstream and Midstream Such as Manufacturing Industries, EPC Projects, TA etc.Good knowledge in conventional NDT & Automatic NDT method
Education
- 2006 - 2008
Experience
-
2023 - Present
Kamit energies Uganda
QA/QC Mechanical Inspector
• Inspection of Tank plumpness, roundness, misalignment, joint ID marking, peaking, and banding. Visual inspection for defects in the weld.
• Inspection of the bottom weld by using Vacuum Box test to ensure the soundness of bottom weld.
• Review ITP, WPS, Weld map and tank drawings compliance to project specification and API TANKS.
• Review Hydro test procedure and ensure for mechanical clearance and test is conducting as per approved procedure.
• Review of documents like QAP,ITP and QA/QC Procedures.
• Material Inspection (i.e. Pipes, Plates, Fasteners, Fittings Forgings etc.) as per applicable code.
• Stage inspection as per approved drawing, QAP,ITP and QA/QC procedures and applicable codes.
• Issue of Inspection Release note after successful completion of final inspection.
• Witness of Hydro tests and Pneumatic tests of Piping’s & Equipment’s.
• To check of orifice flange inspection and pipe flange alignment report.
• To study the P&ID and other circuit diagrams in the test pack.
• Monitoring the calibration of test instruments and equipment’s.
• Review and Interpretation of RT films as per ASME B 31.3,SEC V,SEC VIII,API 1104 & AWS D1.1.
• Inspection and testing activities as per the inspection procedures.
• To check the fit up stage prior and confirm that root gap, off set, bevel angle are with in acceptable limit.
• To witness preheating process and verify the chart.
• Witnessing of activities like PQR, Welder’s qualification Tests, Mechanical testing and preparation of PQR records and WQT certificates.
• Review and Witness that the welding parameters are confirmed to WPS in during welding.
• Review and Check the temperature of electrode as per the WPS.
• To do the visual inspection after completion of the welding.
• Witness and review the post weld heat treatment process and verify the chart.
• To witness MPT, LPT of fillet weld joints, butt weld joints and check the surface & sub surface defect.
Honors & awards
-
2017
Safety awareness
I got this award for extraordinary performance
